RS92 3" RIGID DOOR STOP
RS92 3" Diecast Rigid Door Stop
The Cal-Royal RS92 Rigid Door Stop provides a fixed contact point to help keep a compatible swinging door or its hardware from striking a nearby surface. The RS92 features diecast construction and a molded-screw mounting design. Its listed 3" nominal projection makes it an option where a compact rigid stop suits the opening's clearance and mounting conditions.
Practical Uses
Consider the RS92 for suitable interior doors where a projecting stop can contact the door before the lever, trim, or door edge reaches the wall. Check the actual hardware projection and swing path before selecting a location. Nominal stop length alone does not establish a suitable fit.
Seven architectural finishes provide coordination choices: US10B-Antique Bronze Oiled, US15-Satin Nickel, US15A-Satin Nickel Blackened, US26-Bright Chrome, US26D-Satin Chrome, US3-Bright Brass, and US5-Antique Brass. Finish names do not change the listed diecast construction into solid brass.
Installation and Replacement
Choose a mounting location with adequate screw support and a suitable contact area on the door. Avoid glass, delicate trim, and unsupported panels. Verify that the stop makes contact before the handle or door edge strikes the wall, and check for interference throughout the swing.
Use the manufacturer drawing and actual product to establish mounting preparation. The existing listing and template identify a 5/8" screw-length reference. Confirm suitable pilot-hole preparation and screw engagement for the mounting material rather than assuming thin trim or an unsupported surface will hold securely.
For replacement work, inspect the old mounting hole and surrounding material. A stripped or enlarged hole may require a properly supported new location. After installation, open the door slowly to verify intended contact and check that the stop remains secure during normal use.
Problems It Helps Address
- Door hardware striking nearby surfaces: Establishes a stopping point when placement and projection are appropriate.
- Unplanned contact locations: Allows the installer to select a suitable point of contact before vulnerable trim or hardware meets the wall.
- Missing or damaged rigid stops: Offers a replacement option where mounting and contact geometry match.
- Mismatched hardware: Seven finishes help coordinate the stop with surrounding fittings.
At an interior room doorway, a correctly positioned RS92 lets the door meet the intended stop rather than allowing the handle to knock directly into the wall. Secure screw support and careful contact placement are what make this compact fitting useful in everyday operation.
Product Details
- Part number: RS92
- Type: Rigid door stop
- Construction: Diecast
- Mounting design: Molded screw
- Listed nominal projection: 3"
- Listed mounting-screw reference: 5/8"
- Manufacturer drawing's end-view dimension: 7/8"
- Finish choices: US10B, US15, US15A, US26, US26D, US3, and US5, as named above
Dimensional Check Before Ordering
The manufacturer identifies the RS92 as a 3" stop. Its template shows a 2-7/8" body-length reference plus a 5/8" screw reference, giving a 3-1/2" overall dimension including the screw. Do not mistake that overall dimension for the installed projection.
Confirm the actual installed projection and mounting dimensions before ordering for a tight clearance or matching an existing stop. Use the drawing and actual product for installation rather than scaling the printed page.
Operating Considerations
The RS92 is a rigid contact stop, not a flexible spring stop, hydraulic buffer, door closer, or hold-open device. It does not regulate door speed. Check for loose mounting during routine maintenance and address uncontrolled door movement separately rather than relying on the stop to absorb every impact.
Mounting Template
RS92 Rigid Door Stop Mounting Template