JRS34 4" DIECAST JUMBO RIGID STOP
JRS34 4" Diecast Jumbo Rigid Door Stop
The Cal-Royal JRS34 Diecast Jumbo Rigid Door Stop provides a fixed contact point to help keep a compatible swinging door or its hardware from striking a nearby surface. The JRS34 combines a diecast body with a rigid design and wood-screw attachment. Its listed 4" nominal projection makes clearance and contact placement important when selecting it for an opening.
Practical Uses
Consider the JRS34 for suitable interior openings where a projecting rigid stop can reach the door before the lever or door edge reaches the wall. Check the complete swing path, hardware projection, trim, and mounting support to determine whether the nominal length suits the opening.
Six architectural finishes offer coordination with surrounding hardware: US10B-Antique Bronze Oiled, US15-Satin Nickel, US15A-Satin Nickel Blackened, US26-Bright Chrome, US3-Bright Brass, and US5-Antique Brass. These are finish descriptions, not statements that the diecast body is solid brass.
Installation and Replacement
Position the stop to meet a suitable contact area on the door before the handle, trim, or edge strikes the wall. Avoid glass, delicate moldings, and unsupported panels. Check the full swing for interference and confirm that the mounting location provides adequate support for repeated contact.
The manufacturer drawing identifies one double-threaded wood screw. Use the JRS34 template and actual product to check mounting preparation, and confirm the suitable pilot hole and screw engagement for the mounting material. Do not assume thin trim or an unsupported wall surface will provide a secure fixing.
For replacement work, inspect the existing hole and surrounding material. A stripped or enlarged hole may require a properly supported new location. After fitting, open the door slowly to verify intended contact and confirm that the stop remains secure during normal use.
Problems It Helps Address
- Door hardware striking nearby surfaces: Establishes a stopping point when projection and placement are suitable.
- Insufficient reach from a shorter stop: The listed 4" nominal projection provides a longer contact option where the opening requires it.
- Missing or damaged rigid stops: Offers a replacement option where mounting and contact geometry match.
- Mismatched hardware: Six finishes provide coordination choices.
At an interior office or guest-room door, a correctly positioned JRS34 lets the door meet the intended stop instead of allowing the handle to knock directly into the wall. The right projection and solid screw support matter more than simply replacing the old stop in the same hole.
Product Details
- Part number: JRS34
- Type: Jumbo rigid door stop
- Body material: Diecast
- Listed nominal projection: 4"
- Existing listed mounting-screw length: 3/4"; confirm the current supplied screw and engagement requirements
- Manufacturer mounting reference: One double-threaded wood screw
- Existing specification reference: ANSI / BHMA A156.16
- Finish choices: US10B, US15, US15A, US26, US3, and US5, as named above
Dimensional Check Before Ordering
The manufacturer identifies this as a 4" diecast jumbo door stop, while its dimensional drawing shows a 3-29/32" overall length reference. Treat the listing's 4" value as nominal, and confirm the installed projection and screw dimensions when clearance is critical or an existing stop must be matched.
Use the matching template and actual product for installation rather than scaling a printed page. The drawing also shows a 31/32" end-view dimension; check the complete drawing for the mounting and contact geometry needed by your opening.
Operating Considerations
The JRS34 is a rigid contact stop, not a flexible spring stop, hydraulic buffer, door closer, or hold-open device. It does not regulate door speed. Check for loose mounting during routine maintenance, and address uncontrolled door movement separately rather than relying on the stop to absorb every impact.
Mounting Template
JRS34 Jumbo Rigid Door Stop Mounting Template