SQP-012 BACK TO BACK SQUARE PULL HANDLE
SQP-012 Back-to-Back Square Pull Handle for Wood Doors
Usually Ships in 1–3 Business Days
The Cal-Royal SQP-012 is a back-to-back square pull handle for wood doors, providing a fixed gripping point on both faces. Its square profile suits contemporary sliding-door installations where there is enough clearance for the handles throughout the door's travel.
Practical Uses
- Interior wood sliding doors: Provide a pull on both sides when the opening layout permits.
- Barn-style doors: Coordinate the square handle with the track, privacy hardware, and available wall clearance.
- Replacement installations: Compare the mounting pattern and handle clearance with the existing preparation before choosing a replacement.
Everyday example: For a wood sliding door between an office and meeting room, the installer checks that the wall-side pull will pass the trim and wall throughout the full travel. The two halves are positioned using the model instructions, attached through the door, and tested from both sides without rubbing or interference.
Installation Guidance
Check thickness and hardware: The listing specifies wood doors 1-3/8 to 1-3/4 inches thick. Confirm the actual door, current manufacturer instructions, and supplied fasteners before installation.
Verify the hole pattern: Measure the actual handle and consult the SQP-012 manual before marking or drilling. Do not use overall handle height as the mounting-center measurement.
Allow clearance on both faces: Check the wall-side stand-off, trim, jamb, other hardware, and complete travel path. A back-to-back pull may not suit an opening with limited clearance behind the door.
Attach to suitable door construction: Check the intended fixing area and through-door connection, follow the model's assembly sequence, and tighten evenly without crushing or distorting the door face.
Test before handover: Check both grips for movement, verify fastener engagement, and cycle the door through its full travel from each side.
Problems It Helps Address
- The door needs a grip on each side: Provides a back-to-back handle arrangement.
- A contemporary square profile is wanted: Offers a coordinated fixed-pull appearance.
- Fit must be checked before replacement: A model-specific manual supports preparation and assembly checks.
Product Details
- Part number: SQP-012
- Application: Back-to-back pull for wood doors
- Listed size: 12 inches high × 2-1/2 inches wide × 25/32 inch deep
- Listed mounting centers: 11-7/32 inches; verify against actual hardware before drilling
- Listed door thickness: 1-3/8 to 1-3/4 inches, subject to current instructions and supplied hardware
- Selectable finishes: L1-Black; US32D-Satin Stainless Steel
Selection tip: This fixed pull does not operate a latch or provide privacy locking by itself. Check complete-opening requirements, the actual supplied components, and clearance for both handle halves before ordering.