IRODH CAST IRON DROP DOWN DOOR HOLDER
IRODH Cast Iron Drop Down Door Holder
Usually Ships: 1-3 Business Days
The Cal-Royal IRODH Cast Iron Drop Down Door Holder is a manually operated kick-down holder with a vinyl rubber foot. Lower the arm against a suitable floor surface to hold the door at a chosen position, then raise it clear before moving the door. This listing offers 4-inch and 5-inch arm options, corresponding to the manufacturer's IRODH4 and IRODH5 references.
Practical Uses
- Temporary access: Hold a suitable door open while moving supplies or equipment where a manual hold-open device is permitted.
- Service-area doors: Provide a door-mounted alternative to a loose wedge when the floor and door construction suit the holder.
- Replacement work: Choose the arm length after checking the actual mounting position, floor clearance, and existing hole pattern.
Everyday example: While bringing cartons into a stockroom, a worker opens a suitable door and lowers the holder until its rubber foot contacts the floor. After unloading, the worker raises the arm fully and checks that the door closes normally.
Installation Guidance
Choose the arm length: Select the 4-inch or 5-inch version to suit the actual door-to-floor clearance and mounting geometry. Arm length alone does not establish the correct installation height.
Secure the mounting plate: Attach the holder to sound door material or suitable reinforcement. The manufacturer drawings reference four #7 × 1-inch wood screws; verify the supplied hardware and the appropriate attachment method for the actual door.
Check floor contact: Position the holder so the lowered rubber foot makes stable contact without excessive force or distortion. Floor slope, surface texture, dust, moisture, and foot wear can affect holding performance.
Check the raised position: Confirm that the arm stays clear of the floor and nearby obstructions during normal door operation.
Confirm permitted use: Do not use a manual holder where the opening must remain self-closing or where hold-open operation is not permitted. Check the requirements for the complete opening before installation.
Inspect periodically: Check the foot, pivot, and fastening for wear or looseness. Raise the arm before moving the door rather than dragging the rubber foot across the floor.
Problems It Helps Address
- A door closing during temporary access: Provides manual holding when the installation and floor contact are suitable.
- Loose wedges being misplaced: Keeps the holding device attached to the door.
- Different floor clearances: Offers two arm-length choices for installation planning.
Product Details
- Series: IRODH
- Manufacturer references: IRODH4, 4-inch arm; IRODH5, 5-inch arm
- Construction: Cast iron
- Foot: Black/grey vinyl rubber with concentric grooves
- Operation: Manual drop-down/kick-down holder
- Listed standard reference: ANSI/BHMA A156.16, L11383
Available Finishes
- ALUM
- DURO
Selection tip: Compare the correct model drawing with the door and floor before ordering. This holder is not a hydraulic closer, an automatic release device, or a security lock; its performance depends on installation and floor conditions.