CR2715 SADDLE THRESHOLDS 1/2" H X 5"
CR2715 Commercial Saddle Threshold, 1/2-Inch High x 5-Inch Wide
Our CR2715 saddle threshold has a 1/2-inch-high x 5-inch-wide profile for commercial doorway work calling for this exact model. Choose the required 36, 48, 72, or 96-inch stock length and Alum or Duro finish, then fit it to the measured opening using the matching instructions.
Uses and Selection
- Specified installations: Match CR2715 to the project's threshold detail.
- Replacement work: Check the existing profile, attachment, and required finished length.
- Flooring renovations: Review floor levels, adjacent finishes, and door-bottom clearances before fitting.
Overall height and width do not establish interchangeability with another threshold. Use the exact CR2715 guide rather than assuming another 1/2-inch x 5-inch profile is identical. The selectable stock length is separate from these cross-section dimensions.
Everyday example: A facilities team needs to replace a worn threshold while retaining the existing doorway. They verify CR2715 against the opening detail, measure at the frame base, and select sufficient stock length. After fitting and sealing, they check the door repeatedly to confirm it self-closes and latches without interference.
Installation Checks
- Measure and cut: The guide calls for the exact full width of the opening at the bottom of the frame.
- Fit around the jambs: Trim and notch the ends as necessary for side-jamb stops.
- Prepare attachment: Mark and drill pilot holes through the predrilled threshold holes.
- Check fasteners: The guide specifies #10 x 1-1/2-inch fasteners; the listing identifies wood screws. Verify the supplied kit and substrate suitability.
- Seal: Seal both ends and along the sides.
- Test movement: Operate the door several times to ensure the threshold does not prevent self-closing or latching.
Finish and Optional Coating
The guide identifies Mill Aluminum and Duro, corresponding to the listing's Alum and Duro choices. Sure Step non-slip abrasive coating is a separately identified ordering option; confirm availability rather than assuming the standard selections include it. General family references to brass or stainless thresholds do not establish those materials as choices on this listing.
Problems It Helps Address
- A worn or missing threshold: Provides a defined model and profile for replacement checks.
- A threshold needs site fitting: Supports measured cutting and jamb-end preparation using the exact guide.
- Flooring and hardware need coordination: Makes clearance, sealing, and closing checks part of the installation.
Rated-Opening and Accessibility Coordination
The CR2715 guide carries UBC 7-2 (1997), Category J and a 3-hour positive-pressure reference subject to its material-use and door-construction conditions. Confirm the complete assembly and permitted installation against the applicable listing and project specification. The threshold alone does not establish an opening's fire rating.
For an accessible route, have the responsible project professional verify the installed profile, floor transitions, and complete doorway. Reference logos and nominal dimensions alone do not establish compliance.
Care and Documents
Keep the threshold free of debris. Inspect fasteners, perimeter sealing, and door movement periodically; address looseness or interference with closing before continued use.
Usually Ships: 1-3 Business Days