Cal Royal CR2726 SADDLE THRESHOLDS 1/2" H X 6"
Cal Royal CR2726 SADDLE THRESHOLDS 1/2" H X 6"

CR2726 SADDLE THRESHOLDS 1/2" H X 6"

Write A Review
Regular price $38.90
Sale price $38.90 Regular price $0.00
Unit price
Alum
Duro
Ask a question

Ask a Question

* Required fields

Size guide Share

CR2726 Commercial Saddle Threshold, 1/2-Inch High x 6-Inch Wide

Our CR2726 saddle threshold provides a 1/2-inch-high x 6-inch-wide profile for commercial openings specified for this model. Available selections include 36, 48, 72, and 96-inch stock lengths in Alum or Duro. Check the complete opening detail, floor levels, and door-bottom clearance before selecting and fitting the threshold.

Practical Applications

  • Specified threshold installations: Match the CR2726 profile to the project's doorway detail.
  • Replacement work: Verify height, width, finished length, and attachment requirements against the existing opening.
  • Flooring updates: Coordinate the 6-inch-wide footprint with adjacent materials and the door's movement.

Everyday example: A contractor is updating a commercial doorway that calls for CR2726. They confirm the 1/2-inch height, check where the 6-inch width meets the floor finishes, and measure the frame base. After cutting, securing, and sealing the threshold, they cycle the door to check clearance and reliable self-closing and latching.

Profile and Finish Selection

The height and width describe the cross section, not the selectable stock length. Use the exact CR2726 guide when checking profile fit; similar overall dimensions do not establish interchangeability with another model.

The installation sheet identifies Mill Aluminum and Duro, corresponding to the listing's Alum and Duro choices. Sure Step non-slip abrasive coating is separately identified as an ordering option in the existing information. Confirm availability and ordering details rather than assuming that it is included.

Installation Guidance

  • Measure at the frame base: Cut the threshold to the exact full opening width.
  • Prepare the ends: Trim and notch as necessary for side-jamb stops.
  • Mark and drill: Use the predrilled threshold holes to mark suitable pilot holes.
  • Verify fasteners: The guide specifies #10 x 1-1/2-inch fasteners; the listing identifies wood screws. Confirm supplied contents and suitability for the actual floor substrate.
  • Seal the perimeter: Seal both ends and along the sides.
  • Test the door repeatedly: Confirm that the threshold does not prevent self-closing and latching.

Problems It Helps Address

  • A threshold is damaged or missing: Provides a defined model and size for replacement selection.
  • The opening needs a fitted threshold: Supports measured cutting and jamb-end preparation using model-specific instructions.
  • Floor and door details need coordination: Makes clearance, attachment, sealing, and operation checks part of the installation.

Rated-Opening and Accessibility Coordination

The CR2726 guide identifies UL10B, UL10C, and UBC 7-2 (1997), Category J, with a 3-hour positive-pressure reference subject to its stated material-use and door-construction limits. These are component-use references, not universal approval of every installed opening. Confirm the exact door, frame, threshold, and preparation against the applicable listing and project requirements.

For an accessible route, have the responsible project professional verify the installed profile, floor transitions, clearances, and complete doorway. Nominal dimensions and reference logos alone do not establish accessibility compliance.




Care and Documents

Keep the threshold clear of debris and inspect fastening, perimeter sealing, and door movement periodically. Address loose components or interference with closing before continued use.

Usually Ships: 1-3 Business Days