Cal Royal CR2767 SADDLE THRESHOLDS 1/2" H X 7"
Cal Royal CR2767 SADDLE THRESHOLDS 1/2" H X 7"

CR2767 SADDLE THRESHOLDS 1/2" H X 7"

Write A Review
Regular price $56.20
Sale price $56.20 Regular price $0.00
Unit price
Alum
Duro
Ask a question

Ask a Question

* Required fields

Size guide Share

CR2767 Saddle Threshold, 1/2-Inch High x 7-Inch Wide

Our CR2767 commercial saddle threshold has a 1/2-inch-high x 7-inch-wide profile. Choose it where this exact profile is specified, after reviewing floor levels, doorway clearance, and the complete threshold detail. Stock length choices are 36, 48, 72, and 96 inches in Alum or Duro.

Practical Uses

  • Specified commercial openings: Fit the CR2767 profile across the measured frame base.
  • Replacement work: Match the required cross section, attachment, and finished length.
  • Flooring renovations: Coordinate the 7-inch-wide footprint with adjacent materials and door-bottom hardware.

Everyday example: A maintenance team is replacing a threshold at a doorway specified for CR2767. They check the floor detail and the door's clearance over the 1/2-inch profile, then choose sufficient stock length. After cutting and fitting around the jamb stops, they secure and seal the threshold and test self-closing and latching.

Selection Checks

Height and width describe the cross section, not stock length. Use the exact CR2767 instructions to check fit rather than assuming another model with similar dimensions is interchangeable. Confirm the full finished opening width before cutting.

The installation sheet identifies Mill Aluminum and Duro, corresponding to the listing's finish choices. Sure Step non-slip abrasive coating is an additional ordering option identified in the existing information, not an assumed feature of the standard Alum or Duro selection. Confirm availability separately.

Installation Guidance

  • Measure: Measure at the bottom of the frame and cut to the exact full opening width.
  • Prepare the ends: Trim and notch as required for side-jamb stops.
  • Verify attachment: Check the predrilled mounting arrangement and suitable pilot-hole preparation against the supplied guide.
  • Check fasteners: The guide specifies #10 x 1-1/2-inch fasteners; the listing identifies wood screws. Confirm the supplied kit and substrate suitability.
  • Seal: Seal both ends and along the sides.
  • Test: Operate the door multiple times to ensure the installation does not prevent self-closing or latching.

Problems It Helps Address

  • A damaged or missing threshold: Provides a defined replacement model and profile.
  • An opening needs a fitted threshold: Supports measured cutting and jamb-end preparation.
  • Floor finishes and door movement need coordination: Makes clearance, attachment, sealing, and operation checks part of the fitting process.

Rated-Opening and Accessibility Coordination

The CR2767 guide carries UBC 7-2 (1997), Category J and a 3-hour positive-pressure reference subject to its stated door-construction and material-use conditions. Verify the exact assembly and permitted preparation against the applicable listing and project requirements. The component reference does not establish a complete opening's fire rating.

For an accessible route, have the responsible project professional review the installed profile, floor transitions, clearances, and complete doorway. Nominal dimensions or reference logos alone do not establish compliance.

Care and Documents

Keep the threshold free of debris. Inspect mounting security, perimeter sealing, and door movement periodically. Address looseness or interference with closing before continued use.

Usually Ships: 1-3 Business Days