CR3726 SADDLE THRESHOLDS 1/4" H X 6"
CR3726 Saddle Threshold, 1/4-Inch High x 6-Inch Wide
Our CR3726 commercial saddle threshold has a 1/4-inch-high x 6-inch-wide profile. Use it where the project specifies this exact model, with floor levels and door-bottom clearance checked as part of the complete opening. Stock length choices are 36, 48, 72, and 96 inches in Alum or Duro.
Practical Applications
- Specified doorway work: Match the quarter-inch-high profile to the threshold detail.
- Replacement projects: Check the required cross section, attachment, and finished length.
- Flooring renovations: Coordinate the 6-inch-wide footprint with adjacent finishes and door-bottom hardware.
Everyday example: A contractor is updating an opening specified for CR3726. They check the 1/4-inch height and 6-inch width against the finished floor detail and measure at the base of the frame. After cutting and notching around the jamb stops, they secure and seal the threshold and repeatedly test the door's self-closing and latching.
Profile and Finish Selection
Height and width describe the cross section, not the stock length. Use the matching CR3726 guide to review the profile and preparation; do not select solely by overall dimensions or assume a similar threshold is interchangeable.
The installation sheet identifies Mill Aluminum and Duro, corresponding to the listing's finish choices. Sure Step non-slip abrasive coating is a separately identified ordering option in the existing information, not an assumed feature of either standard finish. Confirm availability separately.
Installation Guidance
- Measure and cut: Measure at the bottom of the frame and cut to the exact full opening width.
- Fit around the jambs: Trim and notch the ends as necessary for side-jamb stops.
- Prepare fastening: Mark and drill suitable pilot holes through the predrilled threshold holes.
- Verify fasteners: The existing listing specifies #10 x 1-1/2-inch wood screws. Check supplied contents and suitability for the actual floor substrate.
- Seal: Seal both ends and along the sides.
- Test: Operate the door multiple times to ensure the threshold does not prevent self-closing and latching.
Problems It Helps Address
- A worn or missing threshold: Provides a defined replacement model and profile.
- An opening needs site fitting: Supports measured cutting and model-specific end preparation.
- Floor and door details need coordination: Makes fastening, sealing, clearance, and operation checks part of installation.
Rated-Opening and Accessibility Coordination
The CR3726 guide identifies UL10B, UL10C, and UBC 7-2 (1997), Category J. Its positive-pressure material-use references are conditional: up to 3 hours for specified classified hollow-metal steel-composite doors in listed steel frames, up to 1-1/2 hours for wood-composite doors, and 20 minutes without hose stream for wood-core doors. Confirm the exact assembly and permitted preparation against the applicable listing and project requirements, rather than treating this as a universal three-hour opening rating.
For an accessible route, have the responsible project professional verify the installed profile, floor transitions, clearances, and complete doorway. The threshold's nominal height alone does not establish accessibility or complete-opening compliance.
Care and Documents
Keep the threshold free of debris. Inspect mounting security, perimeter sealing, and door movement periodically; address looseness or interference with closing before continued use.
Usually Ships: 1-3 Business Days