DIFP218 DRIVE IN FINGER PULL
DIFP218 Drive-In Finger Pull
The Cal-Royal DIFP218 Drive-In Finger Pull provides a recessed finger grip for compatible sliding-door preparations. Its no-nail drive-in design avoids an exposed projecting handle, helping preserve clearance where sliding panels pass each other. Choose a listed architectural finish to coordinate with nearby door hardware.
Practical Uses
- Sliding closet doors: Provide a recessed grip for moving a properly prepared panel.
- Bypass-door layouts: Consider a recessed pull where a projecting handle could interfere with adjacent panels, after checking actual clearance.
- Replacement work: Replace a matching pull only after comparing the existing opening, recess depth, and available door material.
Everyday example: A homeowner slides a closet panel aside using the recessed finger grip rather than grasping the door edge. With the pull properly seated and clearance checked, the adjacent panel can pass without catching on a projecting handle.
Installation Guidance
Check the preparation: Compare the actual pull and manufacturer drawing with the door before cutting. Confirm the required opening, recess depth, door thickness, and sound material around the opening. Do not select a hole size from the model number alone.
Plan the position: Choose a comfortable operating location clear of the door edge, internal components, and existing hardware. For bypass doors, check clearance with both panels in every operating position.
Prepare carefully: Keep the opening clean and accurately sized for the drive-in fit. An oversized or damaged opening may not retain the pull correctly; do not assume the rim will compensate for an unsuitable preparation.
Seat and test: Follow the manufacturer's drive-in installation guidance and protect the finish while seating the pull. Check that it is secure, comfortable to grip, and clear of adjacent panels throughout travel. This is a pull, not a latch or lock.
Problems It Helps Address
- Limited space for projecting hardware: Offers a recessed gripping point for suitable sliding-door layouts.
- Grasping a bare door edge: Provides a defined finger grip for routine opening and closing.
- Visible finish coordination: Offers eight finish choices to match the project.
Product Details
- Part number: DIFP218
- Type: Drive-in finger pull, no nails
- Application: Sliding doors with a compatible preparation
- Packaging: Individually poly-bagged
- Listed standards: ANSI/BHMA A156.9 B22201 and A156.14 D2781
Available Finishes
- US1-Matte Black
- US10B-Antique Bronze Oiled
- US15-Satin Nickel
- US15A-Satin Nickel Blackened
- US26-Bright Chrome
- US26D-Satin Chrome
- US3-Bright Brass
- US5-Antique Brass
Selection tip: Confirm the dimensions against the actual part and manufacturer drawing before preparing a new door or ordering for an existing opening.