PULL1007ADA Engraved Stainless Steel Pull Plates (1" Round Pull Bar) - Cal Royal Hardware
PULL1007ADA Engraved Stainless Steel Pull Plates (1" Round Pull Bar) - Cal Royal Hardware

PULL1007ADA Engraved Stainless Steel Pull Plates (1" Round Pull Bar)

Write A Review
Regular price $91.66
Sale price $91.66 Regular price
Unit price
Ask a question

Ask a Question

* Required fields

Size guide Share

PULL1007ADA Engraved Stainless Steel Pull Plate with 1-Inch Round Pull Bar

The Cal-Royal PULL1007ADA Engraved Stainless Steel Pull Plate combines a 1-inch round pull bar with a 4 × 16-inch plate and black 3/4-inch “PULL” engraving. The bar provides a defined handhold, while the engraved instruction helps users identify the opening direction. Select the listed 8-inch or 10-inch pull center-to-center option to suit the planned installation.

Practical Uses

  • Pull-side door hardware: Provide a handhold and visible direction cue on a suitable door.
  • Interior refurbishment: Coordinate the pull bar and backing plate with existing trim and door preparation.
  • Replacement installations: Compare the selected mounting centers, plate coverage, and actual hole pattern before reusing existing holes.

Everyday example: At an office doorway, a visitor reads the black “PULL” engraving and uses the round bar to open the door. During installation, the maintenance team checks that the chosen 8-inch or 10-inch mounting pattern matches the preparation and that the handle clears nearby hardware.

Installation and Fit Checks

Choose the mounting centers: Measure between the pull mounting points rather than assuming the plate size determines the handle spacing. Confirm the selected 8-inch or 10-inch option against the actual assembly before drilling.

Check plate clearance: Allow room for the 4 × 16-inch plate without covering glazing, molding, locks, or other operating hardware.

Verify door thickness and backing: Ensure the door construction supports both plate and pull fastenings. Confirm screw engagement and the suitability of the supplied hardware for the actual door.

Separate the fastening functions: Plate perimeter screws and the pull-bar attachments serve different purposes. Follow the instructions supplied with the assembly and do not substitute a hole layout from another pull model.

Check use and swing: Position the bar for the intended users, allow adequate hand space, and confirm clearance from the frame, wall, and adjacent trim throughout the door travel.

Test the complete opening: Check that the pull remains firm, the plate sits flat, and the latch and closer operate properly. The pull does not release a separate latch or reduce excessive door-opening resistance.

Problems It Helps Address

  • Opening direction is unclear: Engraved “PULL” lettering provides a visual cue.
  • A door needs a bar and backing plate: Combines a round grip with a coordinated plate.
  • Existing mounting centers differ: Two selectable center-to-center options support selection after measurement.

Product Details

  • Model: PULL1007ADA
  • Type: Engraved stainless-steel pull plate with round pull bar
  • Listed bar diameter: 1 inch
  • Selectable plate size: 4 × 16 inches
  • Selectable pull mounting centers: 8 inches or 10 inches
  • Engraving: 3/4-inch “PULL,” black
  • Existing BHMA reference: J401
  • Listed fasteners: Six #6 × 1/2-inch stainless-steel screws, two 1/4-20 × 2-1/2-inch steel screws, and two steel washers; verify suitability for the actual door

Selection tip: Confirm mounting centers, door thickness, plate coverage, and the actual assembly before ordering or drilling. Evaluate any accessibility requirements for the complete installed door rather than treating a model name as approval of the entire opening.