DSHD105 HEAVY DUTY DOOR PROTECTOR HINGE STOP
DSHD105 Heavy-Duty Hinge-Pin Door Stop
Our DSHD105 is a heavy-duty hinge-pin door stop with a removable nylon bushing, recommended in the matching template for commercial use. Its adjustable angle setting helps establish the door's intended opening limit where a compatible hinge-pin arrangement is suitable. Check the hinge, contact surfaces, and complete opening before selecting this stop.
Practical Uses
- Commercial doorway work: Use the specified hinge-pin stop where the project calls for this mounting arrangement.
- Limited floor or wall mounting locations: Consider hinge-pin mounting only after checking actual hardware and contact clearances.
- Replacement work: Match hinge-pin diameter, hinge size, stop geometry, and the required opening position.
Everyday example: A facilities team needs to limit a door's swing before its handle reaches an adjacent surface. They verify that the hinge and pin suit DSHD105, check where its bumpers will contact, and install it following the matching detail. They adjust the stopping position and test the door, confirming that the stop acts before unwanted contact and does not interfere with closing or latching.
Construction and Fit References
The existing listing identifies solid-brass construction and rubber bumpers, with a removable nylon bushing and adjustable angle setting. The matching template confirms the removable-bushing hinge-pin-stop design. Verify the supplied product and its contact arrangement before fitting.
- Listed hinge-pin diameters: 1/4 inch or 5/16 inch.
- Listed hinge sizes: 3-1/2 x 3-1/2 inches, 4 x 4 inches, and 4-1/2 x 4-1/2 inches.
- Fit check: Nominal hinge size and pin diameter are selection references, not proof of compatibility with every hinge design.
Do not assume suitability for a hinge with a non-removable pin, concealed bearing arrangement, or other special construction. NRP means non-removable pin; verify the hinge's actual design before planning any hinge-pin accessory installation.
Available Finish Choices
This listing offers US10B Antique Bronze Oiled, US15 Satin Nickel, US15A Satin Nickel Blackened, US26 Bright Chrome, US26D Satin Chrome, US3 Bright Brass, and US5 Antique Brass. Coordinate the selected finish with the surrounding hardware.
Installation Checks
- Confirm the hinge: Check model, size, pin diameter, and whether the required pin work is permitted.
- Review the bushing arrangement: Match the supplied stop and bushing to the actual hinge pin.
- Check contact surfaces: Verify that the bumpers meet suitable areas without loading delicate trim or finishes.
- Set the angle: Adjust within the product's intended arrangement so the stop acts before unwanted door or handle contact.
- Coordinate other hardware: Check closer action, seals, trim, and the complete swing path.
- Test after fitting: Verify secure installation, stopping position, and full closing and latching.
Problems It Helps Address
- The door can swing toward an adjacent surface: Provides an adjustable stopping arrangement when correctly selected and installed.
- A specified hinge-pin stop needs replacement: Offers a defined model and fit references.
- Other stop locations are impractical: Provides a hinge-pin-mounted option subject to complete installation checks.
Care and Project Coordination
Inspect the stop, bushing, bumpers, adjustment, and hinge condition periodically. Address looseness, worn contact parts, or changes in the stopping position before continued use. Do not force the door against the stop or use it to compensate for loose hinges or incorrect closer adjustment.
The listing's comparison to IVES #69 and 69F is a cross-reference, not a guarantee of identical geometry or direct replacement. Verify actual fit. For a rated or otherwise specified opening, confirm permitted hardware and preparation against the complete door and frame requirements.