HDFDSH66 HEAVY DUTY FLOOR DOOR STOP
HDFDSH66 Heavy Duty Floor Door Stop and Manual Holder
The Cal-Royal HDFDSH66 Heavy Duty Floor Door Stop combines a floor-mounted stopping point with a manually engaged hook-and-strike holding arrangement. It functions as a stop during normal use and serves as a hold-open device only when the hook is manually engaged in the strike. Its listed construction is solid cast brass or bronze.
Practical Uses
- Door-travel limits: Position the stop to meet a suitable solid area of the door before the handle reaches a wall or adjacent surface.
- Occasional manual holding: Engage the hook when temporary hold-open use is appropriate to the opening.
- Replacement work: Compare the complete stop, hook, strike, and mounting arrangement before replacing existing hardware.
Everyday example: At a suitable interior opening, the door meets the floor stop at the planned position. When temporary holding is permitted, the user manually engages the hook in the strike, then disengages it before closing the door again.
Installation Guidance
Check the opening requirements: Confirm that a mechanical manual hold-open arrangement is permitted before using it, particularly on a door required to self-close. Do not assume this holder releases automatically.
Confirm contact height: Compare the actual stop with the door undercut, threshold, and bottom construction. The contact point must meet a suitable surface rather than pass below the door or strike fragile trim.
Align the hook and strike: Locate both parts so the hook engages without pulling or twisting the door out of its natural stopped position. Check clearance and full disengagement before moving the leaf.
Check the floor and door before drilling: Identify the structural materials and any concealed services. Use the manufacturer's mounting reference and appropriate attachment for each substrate.
Test both functions: Verify secure anchorage, repeatable stop contact, manual hook engagement, and normal closing after release. This device does not provide hydraulic speed control.
Problems It Helps Address
- Excess opening travel: Provides a physical stopping point when correctly positioned.
- A need for occasional manual holding: Adds a hook-and-strike arrangement where permitted.
- Misaligned replacement hardware: A model-specific drawing supports checking the complete assembly before installation.
Product Details
- Part number: HDFDSH66
- Type: Floor door stop and manual holder
- Listed construction: Solid cast brass or bronze
- Hold-open operation: Hook manually engaged in strike; manually released before closing
- Listed standards: ANSI/BHMA A156.16; BHMA L11371; Federal Specification 1329E
Available Finishes
- US26D-Satin Chrome
- US10B-Antique Bronze Oiled
- US26-Bright Chrome
- US3-Bright Brass
Selection tip: Compare the complete manufacturer drawing with the actual door clearance, desired stopping position, and hook reach before ordering or drilling. Confirm the supplied fastening and required mounting preparation for the project.