IVHP23JUMBO HEAVY DUTY HINGE PIN STOP
IVHP23JUMBO Heavy Duty Hinge Pin Stop
The Cal-Royal IVHP23JUMBO Heavy Duty Hinge Pin Stop, identified as IVHP23 in the manufacturer reference, is an adjustable hinge-pin door stop with a removable nylon bushing. The manufacturer recommends it for residential use and lists 1/4-inch or 5/16-inch hinge pins with 3-1/2 × 3-1/2-inch or 4 × 4-inch hinges. Check the actual hinge and contact surfaces before selecting this stop.
Practical Uses
- Residential door travel: Limit opening before a handle or door reaches a nearby wall, where the hinge and contact surfaces are suitable.
- Keeping the floor clear: Use a compatible hinge-pin location instead of installing a separate floor-mounted stop.
- Replacement work: Compare the pin diameter, hinge profile, and stopping arrangement with the existing installation.
Everyday example: On a suitable bedroom door, the installer adjusts the stop to make contact before the lever reaches the wall. The door is then opened slowly to check that both contact points remain secure without marking or flexing the door or trim.
Installation Guidance
Check the actual pin: Verify the 1/4-inch or 5/16-inch pin diameter and hinge geometry. Nominal hinge size alone does not establish fit.
Check pin removability: Do not force out a secured, non-removable, or incompatible hinge pin. Follow the hinge manufacturer's instructions and support the door appropriately during installation.
Fit the bushing correctly: Use the removable nylon bushing as directed for the actual pin and assembly. Confirm a secure fit rather than assuming that any loose or oversized arrangement is acceptable.
Adjust the stopping position: Set the contact points against suitable solid surfaces before the door or handle reaches an obstruction. Avoid fragile molding, glazing, or unsupported material.
Test normal operation: Check that the hinge pin is properly seated, the door swings freely, and the stop does not distort the hinge, door, or trim. Recheck adjustment and contact surfaces periodically.
Problems It Helps Address
- A handle approaching the wall: Provides adjustable travel limitation when correctly fitted.
- A separate floor stop is undesirable: Uses an existing compatible hinge-pin location.
- Replacement fit questions: Published pin and hinge references support checking the actual opening.
Product Details
- Listing designation: IVHP23JUMBO
- Manufacturer model: IVHP23
- Type: Jumbo heavy duty hinge-pin door stop
- Bushing: Removable nylon
- Adjustment: Adjustable angle setting
- Listed pin diameters: 1/4 inch or 5/16 inch
- Manufacturer-listed hinge sizes: 3-1/2 × 3-1/2 inches; 4 × 4 inches
- Manufacturer recommendation: Residential use
Available Finishes
- US10B-Antique Bronze Oiled
- US15-Satin Nickel
- US15A-Satin nickel Blackened
- US26-Bright Chrome
- US26D-Satin Chrome
- US3-Bright Brass
- US5-Antique Brass
Selection tip: Compare the actual hinge, pin, and contact clearances before ordering. A hinge-pin stop is a physical travel limiter, not a hydraulic speed control or hold-open device. Do not assume that a comparable product name guarantees identical preparation or fit.
