JHP11 Jumbo Hinge Pin Door Stop
JHP11 Jumbo Hinge Pin Door Stop
The Cal-Royal JHP11 Jumbo Hinge Pin Door Stop is a residential hinge-pin stop with a removable nylon bushing. It limits door-opening travel at a compatible hinge rather than using a separate floor-mounted stop. The manufacturer catalog lists a 1/4-inch hinge pin and residential hinge sizes of 3-1/2 × 3-1/2 inches or 4 × 4 inches.
Practical Uses
- Residential interior doors: Consider this stop where the hinge, pin, and contact surfaces suit the installation.
- Keeping the floor clear: Use a compatible hinge-pin location without adding a separate floor-mounted stop.
- Replacement projects: Compare actual pin diameter, hinge profile, and surrounding clearance before replacing an existing stop.
Everyday example: At a suitable bedroom door, an installer positions the JHP11 to stop the door before its handle reaches the wall. Slow test openings confirm that the contact points meet sound surfaces without marking or flexing the door or trim.
Installation Guidance
Verify the hinge and pin: Measure the actual pin diameter and inspect the hinge geometry. Nominal leaf size alone does not guarantee fit.
Check pin removability: Do not force out a secured, non-removable, or incompatible pin. Follow the hinge manufacturer's instructions and support the door appropriately during installation.
Check the bushing: Fit the removable nylon bushing according to the supplied instructions. Do not assume that removing it establishes compatibility with an unlisted pin diameter.
Set the stopping position: Arrange the contact points so the handle and door remain clear of obstructions. Avoid fragile molding, glazing, and unsupported thin material.
Test and inspect: Confirm that the pin is properly seated, the door moves freely, and the stop does not distort the hinge, door, or trim. Recheck attachment and contact surfaces periodically.
Problems It Helps Address
- A handle approaching a wall: Limits opening travel when the stop is correctly fitted.
- A floor stop is undesirable: Uses a compatible hinge-pin location.
- Uncertain replacement fit: Manufacturer pin and hinge references help guide selection.
Product Details
- Part number: JHP11
- Type: Jumbo hinge-pin door stop
- Recommended use: Residential door hinges
- Bushing: Removable nylon
- Manufacturer-listed hinge-pin diameter: 1/4 inch
- Manufacturer-listed hinge sizes: 3-1/2 × 3-1/2 inches; 4 × 4 inches
Available Finishes
- US1-Matte Black
- US10B-Antique Bronze Oiled
- US15-Satin Nickel
- US15A-Satin nickel Blackened
- US26-Bright Chrome
- US3-Bright Brass
- US5-Antique Brass
Selection tip: Check the actual pin, hinge profile, and stopping surfaces before ordering. This is a physical travel limiter, not a hydraulic speed control or hold-open device.
