RIS375/RIS625 RISER FOR DOME STOP
RIS375 / RIS625 Aluminum Risers for Dome Stops
Usually Ships in 1–3 Business Days
The Cal-Royal RIS375 and RIS625 raise a compatible dome stop for carpet installations where its bumper would otherwise sit too low to meet the door correctly. Choose the 3/8-inch RIS375 or 5/8-inch RIS625 after checking the finished floor, door clearance, and intended bumper contact point. These are riser accessories, not complete door stops.
Practical Uses
- Carpeted rooms: Raise a compatible dome stop to suit the finished carpet height.
- Flooring replacements: Reassess stop height after new flooring changes the door-to-floor relationship.
- Maintenance work: Compare the two riser heights before selecting a spacer for an existing compatible stop.
Everyday example: After carpet is replaced in an office, the installer finds the existing dome stop's bumper sits below the desired contact point. The installer checks the stop model and trials the appropriate RIS375 or RIS625 height, then secures the assembly into a suitable substrate and tests the door slowly.
Installation Guidance
Confirm the stop model: The listing identifies DSLP4, ZNLS-21, DSHP18, and ZNHS-37 dome stops for this carpet-conversion application. Compare the actual stop base, mounting arrangement, and selected riser before ordering.
Measure from the finished floor: Account for carpet and underlay compression. Confirm the raised bumper meets a suitable part of the door without the door catching the riser or metal stop body.
Anchor into sound material: Carpet and underlay are not structural backing. Select an attachment method suitable for the underlying floor and the complete riser-and-stop assembly.
Check fixing reach: The added height changes the fastening stack. Check the model-specific drawing, actual supplied components, and required substrate engagement before drilling.
Keep the assembly stable: Use the riser as intended with a supported, secure base. Do not use it as a general-purpose levelling shim or assume multiple risers can be stacked.
Test the full swing: Open the door slowly to verify bumper contact and clearance from nearby walls, handles, and trim. Recheck the fixing after initial use.
Problems It Helps Address
- A dome stop sits too low after carpeting: Offers two defined riser heights for a compatible installation.
- The bumper misses its intended contact point: Allows the installer to reassess the stop's vertical position.
- A flooring change alters clearance: Provides a model-specific accessory instead of an improvised spacer.
Product Details
- Models: RIS375 and RIS625
- Selectable heights: RIS375, 3/8 inch; RIS625, 5/8 inch
- Material and finish: Extruded aluminum, mill finish
- Listed footprint: 1-3/4 inches long × 1-1/8 inches wide
- Listed application: Carpet conversion for DSLP4, ZNLS-21, DSHP18, and ZNHS-37 dome stops, subject to actual fit verification
Selection tip: Choose the height for the actual opening, not carpet thickness alone. Verify the complete installation's clearances and applicable project requirements; adding a riser does not by itself establish accessibility compliance.