CONWB42 CONVEX WALL STOP
Ships in 1-3 Business Days
CONWB42 Convex Wall Stop
The Cal-Royal CONWB42 Convex Wall Stop provides a cushioned contact point for a compatible swinging door. Its convex rubber bumper helps reduce direct contact between door hardware and the wall when properly positioned. The CONWB42 is offered in multiple architectural finishes, with stainless steel or solid brass construction identified in the product specifications; confirm the material for the selected finish when it matters to the project.
Practical Uses
Consider the CONWB42 for suitable office, hospitality, retail, or residential openings where a lever or other door hardware could strike the wall. Wall mounting keeps the bumper off the floor and provides a defined contact location without adding a floor-mounted stop to the surrounding area.
The convex contact surface is intended to cushion contact, not retain the door in the open position. Check the actual hardware projection and swing path to confirm that this bumper will make contact before the door, lever, or trim reaches the wall.
Installation and Replacement
Use the applicable model-specific template and actual product to check dimensions and preparation before drilling. Locate the bumper where the intended door or hardware contact will align with the rubber surface. Avoid unsupported door panels, glass, and delicate trim, and verify clearances throughout the swing.
Secure the mounting to a suitable wall substrate or backing. The manufacturer cutsheet identifies a #10 x 1-1/4" wood screw, a #10 toggle anchor, and a #10 x 1-1/4" plastic anchor. Select the appropriate mounting method for the actual wall construction and confirm the hardware supplied. An anchor suitable for one wall type is not automatically suitable for another.
For replacement work, compare the existing preparation and contact position rather than assuming a direct fit. After mounting, open the door slowly to check contact, then verify that the bumper remains secure in normal use. This stop does not control door-closing speed or correct a binding door.
Problems It Helps Address
- Hardware striking the wall: Provides a designated contact point when correctly located.
- Hard, abrupt contact: The convex rubber bumper cushions contact; it does not guarantee silent operation or a mark-free surface.
- Floor obstructions: Wall mounting avoids placing a stop on the floor.
- Worn wall bumpers: Offers a replacement option where mounting, dimensions, and contact geometry are compatible.
At a hotel room or office doorway, a correctly positioned CONWB42 lets the door hardware meet a cushioned bumper rather than knocking directly into the wall. Secure mounting and accurate alignment are what make that small contact point useful in everyday operation.
Product Details
- Part number: CONWB42
- Type: Convex wall stop / bumper
- Contact surface: Convex rubber bumper
- Listed material options: Stainless steel or solid brass; verify the selected finish's construction
- Listed specification references: ANSI / BHMA A156.16, L22201 for brass and L52101 for stainless steel; confirm applicable documentation for project requirements
- Listed finish choices: US10-Satin Bronze, US10B-Antique Bronze Oiled, US26-Bright Chrome, US3-Bright Brass, US32D-Satin Stainless Steel, and US4-Satin Brass
Selection tip: Verify the actual base diameter, profile, projection, and mounting preparation before ordering for a tight clearance or matching an existing bumper. Establish installation dimensions using the applicable manufacturer drawing and actual product.
Mounting Template
CONWB42 Convex Wall Stop Mounting Template