DSHP18 SOLID BRASS DOME STOP HIGH PROFILE
DSHP18 Solid Brass High-Profile Dome Door Stop
Usually Ships in 1-3 Business Days
The Cal-Royal DSHP18 Solid Brass Dome Stop High Profile is a floor-mounted stop for doors with thresholds or undercuts where the stop must reach the door's contact area. Its solid brass dome body provides a defined stopping point to help keep the door or projecting hardware from reaching a nearby wall. Check the actual door clearance and stop profile before selecting a high-profile model.
Practical Uses
- Doors with thresholds: Consider the raised profile where a lower stop would not meet the door correctly.
- Undercut doors: Check the DSHP18 against the bottom gap to establish suitable contact above the door edge.
- Wall-protection projects: Position a floor stop so the door stops before its handle reaches the wall.
Everyday example: An interior door has enough bottom clearance to pass over a lower stop. After checking the door's swing and floor construction, an installer selects a suitable DSHP18 and positions it so the door meets the stop before the lever reaches the adjacent wall.
Installation Guidance
Measure the clearance: Check the undercut, threshold, and floor levels through the full swing. Compare these measurements with the actual stop and manufacturer drawing; a high-profile label alone does not establish fit.
Choose the contact point: Position the stop against a sound area of the door, clear of glazing and delicate trim. Confirm the intended opening angle and handle-to-wall clearance before drilling.
Check the floor: Identify the substrate and check for concealed pipes, wiring, or floor heating. Select suitable anchorage for the actual floor construction and verify supplied fastening rather than assuming one anchor works everywhere.
Mount and test: Secure the stop according to the manufacturer information, then open the door gently to check contact. Keep the floor projection away from normal walking routes where practical. Coordinate with any closer; the stop does not provide hydraulic speed control or hold-open operation.
Problems It Helps Address
- A lower stop missing an undercut door: Offers a high-profile alternative after dimensional fit checks.
- Door or handle contact with a wall: Provides a physical stopping point when correctly positioned.
- Finish coordination: Offers eleven architectural finish selections.
Product Details
- Part number: DSHP18
- Type: High-profile floor dome stop
- Construction: Solid brass
- Listed applications: Doors with thresholds or undercuts
- Listed base height: 3/8 inch
- Listed overall height: 1-3/8 inches
- Base diameter: 1-3/4 inches
- Listed standard: ANSI/BHMA A156.16 L02161, high profile
Available Finishes
- US26D-Satin Chrome
- US32D-Satin Stainless Steel
- US15-Satin Nickel
- US1-Matte Black
- US26-Bright Chrome
- US10-Satin Bronze
- US10B-Antique Bronze Oiled
- US15A-Satin Nickel Blackened
- US3-Bright Brass
- US4-Satin Brass
- US5-Antique Brass
Selection tip: Compare the complete profile and mounting arrangement with the actual door and floor before ordering. A finish name alone should not be used to infer a different body material.