DSLP4 SOLID BRASS DOME STOP LOW PROFILE - Cal Royal Hardware
DSLP4 SOLID BRASS DOME STOP LOW PROFILE - Cal Royal Hardware

DSLP4 SOLID BRASS DOME STOP LOW PROFILE

Write A Review
Regular price $4.40
Sale price $4.40 Regular price $0.00
Unit price
US26D-Satin Chrome
US32D-Satin Stainless Steel
US1-Matte Black
US26-Bright Chrome
US15-Satin Nickel
US15A-Satin Nickel Blackened
US10B-Antique Bronze Oiled
US10-Satin Bronze
US3-Bright Brass
US4-Satin Brass
US5-Antique Brass
Ask a question

Ask a Question

* Required fields

Size guide Share

DSLP4 Solid Brass Low-Profile Dome Door Stop

Usually Ships in 1-3 Business Days

The Cal-Royal DSLP4 Solid Brass Dome Stop Low Profile is a floor-mounted stop listed for doors without thresholds. Its solid brass dome body and rubber bumper provide a defined contact point to help keep the door or projecting hardware from reaching a nearby wall. Check the actual door undercut and stop profile to ensure the door contacts the bumper correctly.

Practical Uses

  • Doors without thresholds: Consider the low-profile design where it suits the door's bottom clearance.
  • Wall protection: Position the stop so the door stops before the handle reaches the adjacent wall.
  • Alternative mounting locations: Use floor mounting where suitable wall or baseboard mounting space is unavailable.

Everyday example: A room door opens toward a wall, and its handle could strike the paintwork. After confirming that the door will meet the DSLP4 bumper rather than pass over it, an installer anchors the stop at a suitable point in the swing.

Installation Guidance

Measure first: Compare the door's bottom gap and floor level with the actual stop and manufacturer drawing. A low-profile stop must still reach a sound contact area of the door.

Choose the location: Establish the intended opening angle and handle-to-wall clearance. Keep contact away from glazing and delicate trim, and place the floor projection outside normal walking routes where practical.

Check the substrate: Identify the floor construction and locate concealed services before drilling. Select anchorage appropriate to the actual substrate; do not assume a supplied plug is suitable for every floor.

Secure and test: Follow the manufacturer information and verify the supplied fastening. Open the door gently after installation to confirm bumper contact and clearance. Coordinate the stopping point with any closer. This stop does not provide hold-open operation or control door speed.

Problems It Helps Address

  • Excess opening travel: Provides a physical stop when correctly located.
  • Door or handle contact with a wall: Helps establish clearance from the surface being protected.
  • Limited wall-stop mounting space: Offers a floor-mounted alternative after checking the layout and substrate.

Product Details

  • Part number: DSLP4
  • Type: Low-profile floor dome stop
  • Construction: Solid brass
  • Contact surface: Rubber bumper
  • Listed application: Doors without thresholds
  • Overall height: 1 inch
  • Base diameter: 1-3/4 inches

Available Finishes

  • US26D-Satin Chrome
  • US32D-Satin Stainless Steel
  • US1-Matte Black
  • US26-Bright Chrome
  • US15-Satin Nickel
  • US15A-Satin Nickel Blackened
  • US10B-Antique Bronze Oiled
  • US10-Satin Bronze
  • US3-Bright Brass
  • US4-Satin Brass
  • US5-Antique Brass

Selection tip: Check the full profile and mounting arrangement against the door and floor before ordering. A finish name alone does not establish a different body material.

Manufacturer Documents