SWB SOLID BRASS WALL CONVEX STOP
Ships in 1-3 Business Days
SWB Solid Brass Convex Wall Stop
The Cal-Royal SWB Solid Brass Convex Wall Stop provides a compact, cushioned contact point to help protect walls from door-hardware impact. The SWB combines a solid brass body with an included grey convex rubber bumper and concealed mounting. Its listed 1-inch base diameter makes it an option where a small contact fitting suits the opening.
Practical Uses
Consider the SWB for suitable residential or commercial interior openings where the door handle can align with a compact wall bumper. Check the handle's contact area, door swing, and required stand-off before choosing this low-profile stop. It is not a substitute for a longer projecting stop where additional clearance is needed.
Eight finish choices provide coordination with nearby hardware: US26D-Satin Chrome, US15-Satin Nickel, US15A-Satin Nickel Blackened, US1-Matte Black, US26-Bright Chrome, US10B-Antique Bronze Oiled, US3-Bright Brass, and US4-Satin Brass.
Installation and Replacement
Move the door slowly to determine the intended contact point before marking the wall. Align the convex rubber bumper with a suitable contact surface and confirm that it will engage before other hardware or the door edge strikes the wall. Avoid concentrating impact on glass, delicate trim, or unsupported surfaces.
Use the applicable SWB template and actual product to check mounting preparation. Manufacturer documents identify a #7 x 1-inch wood screw; the cutsheet also identifies a plastic anchor. Choose a mounting method appropriate to the wall construction and ensure adequate backing or support. Concealed mounting provides a finished appearance, not a guarantee against removal or damage.
Confirm the hardware supplied and follow the applicable instructions for its installation. After mounting, check contact and clearance with the door moving slowly, then verify that the body and rubber bumper remain secure during normal use.
Problems It Helps Address
- Door handles knocking into the wall: Provides a designated contact point when correctly aligned.
- Hard contact at the stopping point: The grey convex rubber bumper cushions impact; it does not guarantee silent operation or mark-free surfaces.
- Limited space for a wall fitting: The compact base suits openings where its reach and contact area are sufficient.
- Exposed mounting appearance: Concealed mounting provides a finished look.
At an interior office doorway, a correctly positioned SWB lets the handle meet the grey rubber bumper instead of knocking directly into the wall. Accurate alignment and solid wall support are essential because the compact bumper must meet the intended contact point each time the door opens.
Product Details
- Part number: SWB
- Type: Convex wall stop
- Body material: Solid brass
- Included bumper: Grey convex rubber
- Mounting: Concealed
- Listed base diameter: 1 inch
- Finish choices: US26D, US15, US15A, US1, US26, US10B, US3, and US4, as named above
Selection tip: Verify the actual installed projection, base dimensions, and mounting preparation before ordering for tight clearance or matching an existing bumper.
Replacement Comparison
The listing describes the SWB as comparable to IVES #WS404CVX. Treat this as a comparison reference, not a guarantee of identical dimensions, interchangeable parts, or matching mounting preparation. Check the complete applicable drawing and actual product before substitution or drilling.
Operating Considerations
The SWB is a contact bumper, not a hold-open device, hydraulic buffer, or door closer. It does not regulate door speed. Inspect the rubber bumper and mounting during routine maintenance, and address uncontrolled door movement separately rather than relying on this compact fitting to absorb every impact.
Mounting Template
SWB Solid Brass Convex Wall Stop Mounting Template