CR552 SURFACE OVERHEAD DOOR HOLDER
CR552 Surface Overhead Door Holder and Stop
The Cal-Royal CR552 Surface Overhead Door Holder belongs to the CR550 Series of medium-duty surface-mounted overhead holders and stops. It limits door-opening travel with a built-in cushioned stop. Choose Stop Only for opening control without holding, or Hold Open when a selectable mechanical holding function is appropriate for the opening.
Practical Uses
- Office and staff doors: Control opening travel on doors subject to normal traffic.
- Openings where a floor stop is unsuitable: Place the stopping mechanism overhead instead of in the walking area.
- Door and hardware updates: Select a surface-mounted solution after checking the door width, hinges, frame preparation, and nearby closer hardware.
Everyday example: A facilities team wants a staff-room door to stop before reaching nearby fittings. They select the correct series size and function, coordinate the holder with the closer, and template the installation for the desired opening angle.
Functions and Size Selection
Stop Only: Limits opening travel. The shock-absorber spring compresses before dead stop, so allow for that movement when checking clearances. It is not a hydraulic closer or a guarantee against damage from every impact.
Hold Open: The holding function engages and releases by pushing or pulling the door. It can be disengaged so the unit acts as a stop only. Select this function only where mechanical holding is appropriate.
- Listed Size 2 option: Door width 23-1/16"–27"; series model CR552S for stop only or CR552H for hold open.
- Listed Size 5 option: Door width 39-1/16"–45"; series model CR555S for stop only or CR555H for hold open.
Selection check: Match the chosen size and function to the manufacturer chart and the actual hinge/pivot arrangement before ordering. Opening-angle and mounting dimensions vary by application.
Installation Guidance
Coordinate with the closer: The manufacturer instructs installers to fit the overhead holder before installing the door closer. Check the complete hardware layout for interference and adequate clearance.
Identify the mounting group: Use the installation template's door-thickness and hinge-style table. Butt hinges, offset pivots, continuous hinges, swing-clear hinges, and other hanging arrangements require the applicable templating details rather than one universal hole pattern.
Template the opening angle: The series accommodates 85°–110° openings when installed to the applicable chart. Select the model, mounting group, and desired angle before locating holes. The instructions measure key dimensions from the hinge centerline and include a separate dead-stop adjustment.
Prepare the supports: Follow the hollow-metal door and frame reinforcement requirements and use fasteners appropriate to the construction. Review all template pages and the actual components before drilling. Install the channel with the shock spring toward the hinge edge as instructed.
Inspect operation: Check full travel, cushioning, fastener security, and surrounding clearances. On hold-open models, test engagement, release, and disengagement. Inspect periodically during service.
Problems It Helps Address
- Excess opening travel: Provides an overhead stopping position when correctly selected and installed.
- Unwanted floor-mounted hardware: Locates the mechanism above the door.
- A need for selectable holding: Offers a hold-open configuration where the opening permits it.
Product Details
- Listing reference: CR552; manufacturer family CR550 Series
- Duty: Medium to light-duty applications with normal traffic
- Mounting: Surface overhead
- Handing: Non-handed / reversible
- Minimum door thickness: 1-3/8"
- Maximum opening: 110°, subject to applicable templating
- Stop: Built-in cushioned stop with shock-absorber spring
- Hardware: Screw packet for installation in wood or metal door and frame
- Listed finishes: US26D-Satin chromium plated; US32D-Satin stainless steel
Manufacturer standards reference: The catalog references ANSI A156.8 and UL listing for the STOP function only. Do not transfer that reference to the hold-open function or assume it establishes suitability for a particular fire-door assembly. Confirm the selected model and installation against the opening's requirements.